Skip to content
Air Conditioning

Swamp Cooler Service in Logan, UT

Swamp cooler shutdown, start-up and repair for Logan homes, so the water line survives winter and the cooler is ready by summer.

Does your Logan swamp cooler need winterizing?

Before Logan's first hard freeze, a swamp cooler needs its water line drained, its pan emptied and cleaned, and its vent closed or covered so cold air stays out of the house all winter. We call that the fall shutdown, and it is one part of the swamp cooler care we offer in Logan. In spring we bring the cooler back with a start-up, and through the summer we repair pumps, belts, floats and motors. An evaporative cooler cools by evaporating water into dry air, which suits Northern Utah's dry summers. Logan is about 19 miles northeast of Brigham City in Cache Valley, where a skipped shutdown can mean a split water line or a cold draft all winter.

Warning signs your Logan swamp cooler was not winterized

A cold draft from the cooler vent

If you feel cold air falling from the ceiling vent where the cooler duct enters the house, the cooler is open to the outdoors. Heat escapes through that same opening and your furnace runs longer.

A split or bulging water line in spring

Water left in the supply line freezes, expands and cracks the tubing or a fitting. You find out when the water is turned back on and it sprays or drips.

Rust and standing water in the pan

A pan that was not drained holds water and debris all winter. By spring it can be rusty, slimy and starting to pit.

A musty smell at the first start-up

Old water, wet pads and leftover debris give off a sour, musty smell the first time the cooler runs in spring, and the house fills with it.

What causes winter damage to swamp coolers in Logan

Water left in the supply line

The cooler's water line is thin and usually runs outside or through an unheated attic. Freeze-thaw cycles and sub-zero nights break it if it is not drained.

No cover or closed damper

Without a cover on the cooler or a closed damper in the duct, cold air pours in and warm air leaks out all winter.

Pads and debris left in place

Wet pads and leaves sitting in the cabinet hold moisture against the metal. That speeds up rust and leaves a smell behind.

A skipped spring start-up

Turning the cooler on in June without a start-up runs old pads, a dry pump and a stiff belt all at once. Small problems turn into bigger ones.

What to expect at a fall shutdown or spring start-up

In the fall, we turn off and drain the water supply line, disconnect it at the cooler, empty and clean the pan, pull or dry the pads and switch off power to the cooler. We close the damper or fit a cover so cold air stays out. If we spot worn parts along the way, we tell you what we found and the price before any repair.

In spring, we reverse the process: new pads where needed, a clean pan, the water line reconnected and checked for leaks, the float set to the right level, and the pump, belt and motor tested under load. We run the cooler until the pads are evenly wet and cool air reaches your rooms. Our technicians are licensed and insured.

Swamp cooler service in Logan

Logan has hot, dry summer days and cool nights, a good match for evaporative cooling. Its winters are long, with freeze-thaw cycles and sub-zero nights, and Cache Valley inversions can hold cold air over the valley for days. That is why the fall shutdown matters as much as the summer service here, and a sealed cooler vent keeps those cold stretches outside where they belong. The same care applies in older homes in established neighborhoods and in newer subdivisions. Our Logan service area page lists everything else we do in town.

Related services in Logan

See our swamp cooler service page for evaporative cooler care across Northern Utah. Fall is also the right time for furnace maintenance, so the heat is ready when the cooler is shut down. To manage heating and cooling from your phone, see smart thermostat installation in Logan. Hard water scale on cooler parts shows up in your plumbing too, and water softener installation in Logan treats it.

Schedule your Logan swamp cooler shutdown or start-up

Call (435) 730-2536 Monday to Friday, 8 AM to 6 PM, or schedule online. Book the shutdown in early fall, before the first hard freeze, and the start-up in late spring.

Frequently asked questions

When should I winterize my swamp cooler in Logan?+
Before the first hard freeze, usually in early fall. Once nights start dropping below freezing, water left in the line can freeze and split it.
Do I need a cover on my roof cooler in winter?+
A cover, a closed damper or both keep cold air from coming down the duct and warm air from escaping. We can close up the cooler during a fall shutdown.
What happens if I forget to drain the water line?+
The line or a fitting can split when the water freezes. You usually find the leak in spring when the water is turned back on, and we can replace the line then.
Do you offer spring start-ups too?+
Yes. A spring start-up cleans the pan, replaces worn pads, reconnects the water line and tests the pump, belt and motor before the heat arrives.

Need Swamp Cooler Service in Logan, UT?

Call Your Comfort Heating & Air or request service online. Free estimates on new system installations.