Generator Services in Ogden, UT

Is your Ogden home or business ready for the next power outage?

If an outage would leave your Ogden home without cooling, refrigeration or a working sump pump, or stop work at your business, a standby generator keeps those circuits running until the power comes back. We install standby generators for homes and small businesses. We also maintain them and repair units that will not start or will not take over the load. Own a portable generator? We can add a transfer switch so you can use it safely, without cords running through a window.

Warning signs your generator needs service

It skipped or failed its self-test

Standby generators run a short self-test on a schedule. If you have not heard it run in a while, or the controller shows a fault after the test, it needs a look.

Warning lights on the controller

The control panel on the unit reports problems with the battery, oil, fuel or wiring. A steady or flashing warning light is your cue to call.

Hard starts or rough running

A generator that cranks slowly, stalls or runs unevenly during its test is likely to struggle under a full load in a real outage.

Leaks, smells or debris around the unit

Oil on the pad, a fuel smell or leaves and debris packed inside the enclosure all point to problems that should be fixed before the next outage.

Common causes of generator failures in Ogden

Maintenance that slipped

Generators sit idle most of the year, so upkeep is easy to forget. Old oil, a dirty air filter and worn spark plugs add up until the engine refuses to start.

Battery and charger problems

The starting battery is kept charged by a small charger inside the unit. If either one fails, the generator may not crank when the power drops.

Critters and debris in the enclosure

Mice and insects look for sheltered spots, and a generator enclosure qualifies. Chewed wires and blocked vents are common finds.

A generator too small for the load

If you added an air conditioner, a hot tub or a shop since the generator went in, it may now be asked to carry more than it can. Overloads trip breakers and shut the unit down.

What to expect when we service your generator

For a unit that is not working right, we start by reading the controller's fault history and asking what you have seen. We check the battery and charger, oil, filters, spark plugs, fuel supply and wiring, then test the transfer switch. Once we know the cause, we explain it and give you the price before any work starts.

Maintenance visits follow the same checklist with an oil and filter change and a test run, so you know the generator will carry your circuits. For a new installation, we visit first to look at your panel and fuel source. We help you choose between whole-home and essential-circuit coverage, then recommend a size. We offer free estimates on new system installations. After installing, we simulate an outage to prove the unit starts and transfers power on its own, then walk you through how it works.

Generator services in Ogden

Ogden is about 19 miles south of Brigham City in Weber County. Cold winters with freeze-thaw cycles and hot, dry summers both lean hard on the power at home. Furnaces run in January and air conditioners in July. Ogden has older homes in established neighborhoods alongside newer subdivisions, and an older electrical panel sometimes needs extra work before a transfer switch can go in. We check that on the first visit. Learn more on our Ogden service area page.

Related services in Ogden

Our generator services page covers backup power for all of Northern Utah. Basements that depend on a pump should also see sump pumps in Ogden. If you need a new gas supply for a standby unit, see gas lines. Business owners can find the heating and cooling side on our commercial HVAC page.

Schedule generator service in Ogden

Call (435) 730-2536 Monday to Friday, 8 AM to 6 PM, or schedule online. If your generator shows a code on its display, write it down before you call.